6*6KW Digital Dimmer Pack
With over loading and short circuit double protection switch
A.B.C three posture working indicator light, with bipod’s and three
Trilby’s switch it’s good for using
Net weight: 11kg
Use 【Enter】key to select menu, press【Enter】key once, select one menu, choice for the cycle.
DMX Original Loop Setting
Start the default boot drive circuit for 001, for re-set press and hold the 【Enter】 key 2 seconds, flashing characters, into the set state, Digital tube left one of the first loop for the start of the optional 100-digit number of 0-5,left the first two for the start of the loop optional 10-digit number of 0-9, from left to start the first three-loop single-digit figures 0-9 optional, DMX select the code you need after a long press 【Enter】 key to withdraw from two seconds to confirm.
(Note that: The scope of the local loop for the start :001-512, starting circuit for the 000, the set-up does not work, can not withdraw from the settings, start circuit is greater than 512, the set-up does not work, can not withdraw from the set)
Loop Brightness Value Of View
Press 【Enter】 key to enter the loop to view the status of the brightness value, a digital control left the first one that the current loop;
"•" as a separator; left the first two that the median brightness value of 10; left from the first three months that the brightness value of bit
Number; select circuit according 【▲】 and 【▼】 key to increment and decrement loop recycling options, from the 1-2-3 - ... ... -6-1-2.
Signal To Maintain Set
a. Press 【Enter】 button to select the signal to maintain the menu
That H = 0 to maintain the final ban on DMX signal
H = 1 that allows to keep the last DMX signal
b. Select the state you need to hold down after 【Enter】 key 2 seconds, character blinking, into the signal to maintain the status is set.
Press 【▲】 key, to allow DMX signal to maintain.
Press 【▼】 key, to maintain the prohibition of DMX signal.
Analog Signal To Control The State Set (Of this model is invalid)
The models do not deal with analog signals, it is not necessary to set up.
Press 【Enter】 button to select the pre-setting menu, it started blinking characters
Press 【▲】, incremental cycle set, that is, 0-1-2 - ... -9-0-1-2 ...
Press 【▼】, reduced cycle set, that is, 0-9-8 - ... ... -1-0-9-8.
【Enter】 key to hold down two seconds to confirm settings and exit or wait 20 seconds after the silicon box set will be automatically confirmed and out.
(Description of the function-- Preheat the value box on the silicon circuit to set a brightness value of the smaller, warm-up to the lamp load, the brightness value as the warm-up value. Value can be set up to reduce the impact of pre-heating current, extended lamp life. Setting the scope of pre-0-9%.)